How much salt for a 30,000 gallon pool

Starting with plain water, you'll pour roughly 801 lb of salt into a 30,000 gallon pool to hit 3,200 ppm (parts per million, the number a salt test shows). That works out to 20 bags at 40 lb each. Got some salt in the water already? Enter your reading and watch the bag count shrink.

Units Gallons, pounds Liters, kilograms

Pool volume in gallonsgal

Don't know the gallons? Measure the pool

Pool shapeRectangleOvalRoundKidney

A: lengthftB: widthftShallow end depthftDeep end depthft

The gallons above fill in as you measure.

Salt reading now ppmYour chlorinatorTarget to dose to ppm

Example For 30,000 gallons, from 0 to 3,200 ppm. Type yours to see your bags.

Buy 20 bags of

Add 800 lb in all: pour 19 bags now, then bag 20 after you retest.

Pump on. Pour it around the deep end, not into the skimmer.
Brush any salt off the floor until it's gone.
Run the pump 24 hours and test. Add the rest only if the reading is still short.

How this is worked out

Gallons = A × B × average depth × 7.5 for a rectangle, 6.7 for an oval and 5.9 for a round pool (diameter × diameter), the factors in Hayward's manual; 7.0 for a kidney (length × average width), from Inyo's sizing guide. Pounds of salt = (target ppm − your ppm) × gallons × 8.34 ÷ 1,000,000. A gallon of water weighs 8.34 pounds. Bags round up. In liters: kilograms = ppm difference × liters ÷ 1,000,000.

Salt for 30,000 gallons by current reading

Reading now	to 3,000 ppm	to 3,200 ppm	to 3,600 ppm
0 ppm	Buy 19 bagsadd 751 lb	Buy 20 bagsadd 800 lb	Buy 23 bagsadd 901 lb
1,000 ppm	Buy 13 bagsadd 500 lb	Buy 14 bagsadd 550 lb	Buy 17 bagsadd 651 lb
1,500 ppm	Buy 10 bagsadd 375 lb	Buy 11 bagsadd 425 lb	Buy 14 bagsadd 525 lb
2,000 ppm	Buy 7 bagsadd 250 lb	Buy 8 bagsadd 300 lb	Buy 10 bagsadd 400 lb
2,500 ppm	Buy 4 bagsadd 125 lb	Buy 5 bagsadd 175 lb	Buy 7 bagsadd 275 lb
2,800 ppm	Buy 2 bagsadd 50 lb	Buy 3 bagsadd 100 lb	Buy 5 bagsadd 200 lb
3,000 ppm	Already there	Buy 2 bagsadd 50 lb	Buy 4 bagsadd 150 lb

Every bag is 40 lb and the count rounds up. Pour all but the final bag, let the pump run a day, then test before you open it.

Intex and TruClear aim for 3,000 ppm, Hayward for 3,200 ppm and Pentair for 3,600 ppm. The chart by chlorinator lists every manufacturer's number.

Good to know at 30,000 gallons

The AquaRite manual carries a Hayward chart with 800 lb for 30,000 gallons starting from zero, which matches the number here.

CircuPool's advice is to buy a cell sized for 1.5 to 2 times the water you hold. For this pool that is 45,000 to 60,000 gallons, which fits the Pentair IntelliChlor IC60 or the Pentair IntelliChlor Plus60.

Questions people bring to the counter

How much does a backwash or a rainy week cost me in salt?

Only the water you lose takes salt with it. If a top-up brings this pool from 2,800 back to 3,200 ppm, that's 100 lb: buy 3 bags of 40 lb.

How can I tell if my pool has enough salt?

Test the water. Most chlorinators light a low-salt warning below their range. A strip or drop kit reads in ppm, and that number goes in the salt reading box.

Next size down or up: 25,000 gal or 35,000 gal. Every size is on the per 1,000 gallons chart.